Instructions
1. Load motorcycle into van/trailer, placing the front wheel against a secure stop
2. Place machine on side/centre/paddock stand, or get a second person to hold the machine until secure.
3. Grasp the two cuffs, one in each hand and pull apart far enough to slip the cuffs over each grip (see diagram ) being careful not to foul any switch gear or levers
4. Pull down on both end loops and attach to your own tie down hooks, making sure that the anchor points pull down and slightly forward on to the front wheel stop. The tie down points should always be as far apart as possible to better triangulate the support of your bike
Note :
- Additional tie downs are required to secure the rear of the motorcycle.
- The user of the Motrax BikeStrap assumes full responsibility for determining the safety and suitability of this device and liability is therefore limited to the replacement of the BarStrap if proved to be defective in workmanship or materials.